37MR3-5_SDS.pdf

a
STABOND CORPORATION STABONDLABG@YAHOO. COM
1722 W. 139 STREET tel. 310 380 6168
GARDENA, CA 90249 fax 310 329 2729
STABOND MR 3
PRINCIPAL AND GENERAL USE :
Stabond Mold Release #3 has been developed to facilitate the removal of polyurethane parts
from a mold,
The mold should be thoroughly cleaned and dry. Preheat the mold to 120 F. Either brush or
Spray the mold release to the warm, dry surface. Then warm the mold and drive off the
solvent by blowing air over the surface. The mold is now ready for use.
Porous molds e.g. Plaster of Paris, are not recommended, but if used, must first be sealed
with lacquex ox similar coating.
PROPERTIES
TYPE: Wax . SHELF LIFE: 12 months
COLOR: White THINNER: Stabond T-Thinner
SOLIDS: 10% VISCOSITY: Very Thin Syrup
COVERAGE: 300 sq. ft. /gallon FLASH POINT: < 0 F WI/GAL: 6,09 lbs STORAGE For maximum shelf life, store material in cool dry area and keep container tightly sealed. 4 Storage temperature of 60 -80 F. are recommended. Lower storage temperature will cause a temporary increase in viscosity. Rotate stock on a First in First out basis. DANGER : Extremely flammable. Toxic. Vapors may ignite explosively. Provide fresh air cross ventilation to prevent build-up of vapors. Keep away from beat, sparks and from open flame. Do not smoke, Sxtinguish all flames and pilot lights and turn off all non explosion proof electrical equipment and sources of ignition during use and until vapors are dissipated. Avoid prolonged ox repeated breathing of vapors. Close container after use. Contains aromatic and aliphatic hydrocarbons. REEP OUI OF REACH OF CHILDREN. Harmful or fatal if swallowed. If swallowed do not induce vomiting, seek immediate medical attention. THOROUGHLY READ THE MSDS FOR THIS PRODUCT PRIOR TO USING IT. IMPORTANT Suggestions for the use of this product are based on tests believed to be reliable; however, the user should determine suitability for the intended use by his own evaluation. Because the use of the material is beyond our contro), neither the seller nor the manufacturer ghall be liable for any injury, loss, or damage, direct or consequential, arising out of the use or inability to use this product. Seller and manufacturexr s sole obligation shall be replacement of material proved to be defective. 02/05