37FK1000L_TDS.pdf

@ Finish are
2 ep SE ENS SE TR EES
1000L Clean & Seal
Prior to any mold release wax application, we highly
Hi-Low Liq u id Wax recommend all molds be cleaned and sealed using our #69
Mold Cleaner and Stripper or #135-80 for a deeper clean and
our #86 Seal Kote to seal up any porosity.
ae
Application Process
2 Once the mold is properly broken in using a paste wax, like
as 5 our #1000P Hi-Low Paste Wax, then 1000L can be applied.
| (eesy Step 1: Spread evenly and agitate lightly
| me | Step 2: Allow 15-30 mins to dry and then wipe.
Litt } Repeat 1 or 2 more times and then continue releasing. Repeat
this process again once pulls start to get difficult.
i aeeemenenemenmetl This product contains sufficient waxes to continue easy
a demolding and multiple releases. It reactivates and spreads
Interphase Wax Lquld Gold the paste wax deterring any possible wax build up or surface
_ tension.
Description
The charm of 1000L is it allows you to get even more releases Safety Data Sheet
in a multiple release cycle with less effort. It reduces wax build Safety Date Sheets are available for all Finish Kare products
up and surface tension, while redistributing and smoothing and should be consulted prior to use
out the existing waxes to prepping your mold to release the
next part. Storage and Shelf Life
. . Store tightly closed container in a dry, cool place that is well
Once the pulls start to get a little harder instead of doing a ventilated. Do not handle or store near open flame, heat or
clean re-layup, simply apply 10001 Liquid Wax and continue other sources of ignition. Shelf life is 6 months after opening.
releasing.
LIMITATIONS OF LIABILITY
. To the best of our knowledge, the data presented here is true and accurate, but is
Features & Benefits subject to change without prior notice. User is kindly requested to contact Finish Kare
Increased Number of Releases Products to verify the correctness before specifying or ordering. Since we don t know
. – how the product will be used we cannot assume any responsibilty for its use,
Instead of reapplying paste wax, 10001 lets you get performance, or any injuries resulting from its use. Liability if any, is limited to
more releases from the same initial layup replacement of defective product. No warranty or guarantee of any kind is expressed or
* It also increases protection of the molds and helps to Implied by Finish Kare Products, inc.
prolong the multiple release cycle
Saves Time
* Liquid Wax dries quickly, which cuts down on wait
time and lets your team get back to work faster
Minimal Elbow Grease Required
Due toits liquid nature 1000L is quick to apply.
e The unique solvents do the heavy lifting by easily
liquefying the mold release waxes which requires
very little effort to apply
|p SES SS SESS SE SES ESSE SESS SS SS
1726 Floradale Ave., So. El Monte, CA 91733 | 626.443.8983 | sales@FinishKare.com | FinishKare.com