3788H_TDS.pdf

@ Chem A :
Trend < y NN =e ee Sivas fi | Release Innovation | a .. i 1 . PRODUCT DATA SHEET Chem-Trend 88-H Aerosol Release Agent Description Handling Chem-Trend 88H Aerosol is a semi-permanent, dry-film We believe Chem-Trend 88H Aerosol has a low degree fluoropolymer-based release agent and lubricant. of hazard when used as intended. For more It can be used for many types of molding operations, information, request a copy of Chem-Trend s Safety especially where abrasion is a problem. Chem-Trend 88H Freq PY Data Sheet. Aerosol incorporates a system to tightly bond the release film to the mold surface for maximum abrasive resistance. Packaging Properly applied, Chem-Trend 88H Aerosol will not attract Chem-Trend 88H Aerosol is available in case quantities, or hold dust. Because the release agent does not transfer 12 cans per case. Please contact Chem-Trend customer from the mold to the part, there is no effect on post- service for details. decoration of the molded parts. Chem-Trend 88H Aerosol is particularly effective on _ a vinyls, polyesters, epoxies, phenolics and polypropylene. ar aee Sage Further Information rae oa Chem-Trend 88H Aerosol is also recommended for use in Request information on our complete range of materials: custom- releasing silicone rubber from metal or plastic molds. | formulated release agents for polyur thane molding; tire lubes and =| Recommended uses are casting, potting, hand lay-up, METI MER Oe Saas encapsulating, filament winding, injection molding, vacuum ; a ; ; ; bag molding, compression molding and spray booth peel While the technical information and suggestions for use contained herein are release. Chem-Trend 88H Aerosol can also be used believed to be accurate and reliable, nothing stated in this bulletin isto be successfully for dry lubrication of rollers, machines, guides, taken as a warranty either expressed or implied. conveyors, and similar areas where anti-sticking properties and superior lubrication are desires. Application Instructions 1. SHAKE CAN WELL BEFORE USE. 2. Apply Chem-Trend 88H Aerosol only to clean surfaces. A continuous film is required for proper performance. Chem-Trend 88H Aerosol is recommended for mold temperatures above 121 C/250 F. 3. Hold can 20-25 cm/8-10" from surface. 4. Apply a light, uniform coating using a sweeping motion. DO NOT OVERSPRAY. Excessive application may result in a frosted surface which can be restored to a luster by buffing. Multiple releases are common with CT-88H Aerosol and maximum pulls before touch-up should be determined by progressively reducing applications or amount applied ented Chem-Trend L.P, | 1445 W. McPherson Park | Howell, Michigan 102615 78 FREUDENBERG Tel 517.546,4520 | U.S./Canada: 800-727-7730 | Fax: 517-548-5370 | ChemTrend.com Copyright Chem-Trend L.P,, All Rights Reserved