34RJ822_TDS.pdf

MAX {001 Poe MARSH
COMPANY
BETTER TOOLS MAKE BETTER Parts:
Typical Chemical Compositions
AlO,+3H,0 99.5% MaxTool products are engineered alumina trihydrate (ATH) fillers
L.0.1 (100 C) 34.5% | with unique particle size distribution developed for use in tooling resin
SiO, 0.01% | systems. MaxTool products are produced with careful attention to SQC
Fe,0, 0.006% (statistical quality control) and provide improved processing, reduced
REXOUEE) 0.30% | cost and lower VOC’s versus unfilled systems.
Free moisture 0.3% Max
MaxTool 710 710 General Characteristics aiaster Tool Production
+ ax Lool allows faster laminate
Test results show using MaxTool PE EIMGEIIAOIIDE LOSE -OIIAOGS development with less heat build up.
Paeee : Specific Gravity 2.42
710 decreases viscosity build as = 5
compared to other filler systems at Beagle Temp. 428 F (220 C)
similar loading percentages which Refractive Index 1.57 Low Shrink:
allows increased filler percentage Mohs Hardness 25-35 ea Ea
oe MaxTool reduces shrinkage resulting in
maximizing the overall benefits of Appearance Crystalline Powder .
. . – less tool stress, no print through,
using a filled resin system. Color Off White / Tan alert nation en ear Eee antec
MaxTool 815
_ =-‘- Typical Physical Properties| MT710 | MT815 M Keduced Cost .
r ax lool can replace up to
MaxTool 815 utilizes our state of | Packed Bulk Density (Ibi) 50% of resin by weight, thus
the art filler technology allowing | Loose Bulk Density (bit) reducing your resin costs.
you to fill your tooling resin up to __| Oil Absorption (ml/100g)
50% by weight with minimal |Median Particle Size(um) | 8 | 12 | 12 |
viscosity build. +100 mesh (%) Po fo fo | Lower VOC’s
veivommssin( (i) (03 | 1 | 6 | MaxTool will reduce your
+325 mesh (7) VOC emissions by reducing
MaxTool Lite 170 tooling resin content.
MaxTool Lite 170 features all the
benefits of MaxTool 710 with a 25%
weight reduction in the laminate as
compared to MaxTool 710 and 815. a y
800-338-7900 phone 248-948-6460 fax * 888-514-8600 customer care
salesinfo@rjmarshall.com www.Rjmarshall.com
All statements, technical information and recommendations are based on tests we believe to be reliable, the accuracy or completeness is not guaranteed, and the following is made in place of all warranties,
expressed or implied. Our only obigaton isto replace product proved fo be defective. We shall nt be liable for any injury, loss or damage, dect or indirect, rom using oF not being abe fo use the product
Before using, customer must detemine the suit ofthe product for he intended use and customer assumes the respon, These Salements may notbe changed exceptBy an agreement signed by sn
officer of The RJ. Marshall Company. June 2015